Doug's Sword Canes Page

On December 4, 2002 I received some sword cane blades which I can make available to amateur sword cane makers.

There are two styles. Both are made of stainless steel, for use in asian sword canes.

The first style is double edged and has a very short tang, which you can epoxy or drill and pin into a handle. This blade is 1/8" thick, 5/8" wide at the widest end, and 18-1/2" long. Cost is $20 plus postage.

The second style is double edged for only about 6 inches from the point and has a single edge for the full length on the other side. It has a short, threaded tang that measures 6mm with 1.25mm. thread pitch. It is 1/8" thick, 1/2" wide at the widest end, and 19" long. Cost is $25 plus postage.




------home ----- back to Swordmaking Page, or ----e-mail me. ----- updated December 4, 2002